Kedanone 12V 6800mAh Li-ion Rechargeable Batteries with BMS Lithium Battery packs Protection Board for Monitoring+12.6V Charger 

Pay attention: This battery does not apply to electric drills. 

Product Description:

Rated voltage: 11.1V-12.6V
Nominal capacity: 6800mAh
Standard discharge current: 0.2C
Maximum discharge current: 1C
Products: ≤ 250m ohm internal resistance
The battery pack built-in battery protection board of PCB!

Battery discharge Requirements

1: input: 5.5 x 2.1 plug wire
2: output: 22# thread that is 150 mm long
3: the maximum instantaneous current: 5A
4: maximum working current: 3A
5: output input if there is any other requirement can be contact with the owner, the above parameters for the default delivery

The battery requirements

1: need li-ion battery chargers for; Constant current constant voltage;
2: the charging voltage: 12.6V
3: charging current: 1A
4: supporting the charger is charging when the red light is full of green light

Applicable scope

All the 12 v electric equipment, washing equipment, coal, hernia lamp, instead of the 12 v battery, instruments and meters, amplifiers, monitoring, electric class, all sorts of article 12 v lamp,Monitoring equipment

Lithium battery common sense

1. You must use a 12.6 V li-ion battery charger charging standard.
2. The ban on large current discharge.
3. Prohibited discharge, single battery voltage should not be below 2.5 V.
4. It is strictly prohibited to disassemble, short circuit batteries, most likely caused by short circuit on fire.